Product ID:LATEX ENAMEL UNDERCOAT, PV 62
MSDS Date:01/01/1989
FSC:8010
NIIN:00N016671
MSDS Number: BKRZB

EVR-GARD COATINGS CO

16400 GARFIELD AVE
PARAMOUNT, CA 90723
US

Emergency Phone: 213-531-0131

Info Phone: 213-541-0131

Cage: 5G582

EVR-GARD COATINGS CO

PARAMOUNT, CA 90723 US

Telephone: 310-531-0131

Cage: 5G582

ETHYLENE GLYCOL (SARA III)

CAS: 107-21-1

RTECS: KW2975000

OSHA PEL C 50 PPM

ACGIH TLV: C 50 PPM,VAPOR; 9192

EPA Report Quantity: 1 LB

DOT Report Quantity: 1 LB

PROPIONIC ACID, 2-METHYL-MONOESTER W/2,2,4-TRIMETHYL -1, 3-

CAS: 25265-77-4

RTECS: UF6000000

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:NO Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:PROLONGED INHALATION MAY CAUSE
HEADACHE, NAUSEA & DIZZINESS. SKIN/EYE: IRRITANT. REDNESS OR RASH
ON SKIN. INGEST:MAY CAUSE HEADACHE, NAUSEA & DIZZINESS.
Explanation of Carcinogenicity:NOT RELEVANT.
Effects of Overexposure:SEE HEALTH HAZARDS.
Medical Cond Aggravated by Exposure:PRLNG CONTACT WITH MATERIAL MAY
CAUSE DERMATITIS.

First Aid:EYES:FLUSH W/CLEAN WATER FOR AT LEAST 15 MIN. GET MD.
SKIN:REMOVE CONTAM CLTHING. WASH SKIN W/PLENTY OF SOAPY WATER. GET
MD. INHAL:REMOVE TO FRESH AIR. GET MD. INGEST:INDUCE VOMIT W/1-OZ
OF SYRUP OF I PECAC FOLLOWED IN 5 MINUTES W/GLASS OF WATER. CALL
MD.

Lower Limits:0.6%
Extinguishing Media:FOAM, ALCOHOL FOAM, CO*2, DRY CHEMICAL, WATER FOG.
Fire Fighting Procedures:WEAR NIOSH/MSHA APPROVED SCBA & FULL PROT
EQUIPMENT . THIS IS A WATER-BASED PRODUCT. WILL NOT SUPPORT
COMBUSTION.
Unusual Fire/Explosion Hazard:NONE SPECIFIED BY MANUFACTURER.

Spill Release Procedures:ABSORB SPILL W/ANY ABSORBENT MATERIAL-SAWDUST,
SAND, CLAYS, ETC., & FLUSH SPILL AREA W/LOTS OF WATER.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling and Storage Precautions:STABLE UNDER NORMAL USE & STORAGE
CONDITIONS. KEEP OUT OF REACH OF CHILDREN. KEEP FROM FREEZING.
Other Precautions:DO NOT TAKE INTERNALLY.

Respiratory Protection:USE NIOSH/MSHA APPROVED RESPIRATOR APPROPRIATE
FOR EXPOSURE OF CONCERN DURING APPLICATION TO AVOID EXCESSIVE
INHAL OF VAPORS. OPEN WINDOWS & DOORS/USE OTHER MEANS TO INSURE
FRESH AIR ENTRY DURI NG APPLICATION & DRYING.
Ventilation:PROVIDE ADEQ VENT AT ALL TIMES DURING HANDLING &
APPLICATION OF THIS PRODUCT.
Protective Gloves:BUNA N.
Eye Protection:CHEMICAL WORKERS GOGGLES .
Other Protective Equipment:NONE SPECIFIED BY MANUFACTURER.
Work Hygienic Practices:NONE SPECIFIED BY MANUFACTURER.
Supplemental Safety and Health
NONE SPECIFIED BY MANUFACTURER.

HCC:N1
Vapor Pres:SEE ING 1
Vapor Density:>AIR
Spec Gravity:1.2
Evaporation Rate & Reference:SLOWER THAN ETHER.
Solubility in Water:DILUTABLE.
Appearance and Odor:WHITE PAINT-SLIGHT AMMONIA SMELL.

NONE SPECIFIED BY MANUFACTURER.
Stability Condition to Avoid:NONE SPECIFIED BY MANUFACTURER.
Hazardous Decomposition Products:NONE SPECIFIED BY MANUFACTURER.

Waste Disposal Methods:PLACE ALL HAZARDOUS WASTES, INCLUDING ABSORBENTS
USED FOR SPILLS, IN 55-GAL METAL DRUMS & DISPOSE IN APPROVED
DUMPSITE IN ACCORDANCE WITH PRESCRIBED FEDERAL, STATE & LOCAL
REGULATIONS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.